General Europe [Products Information]

6/5/4/3 CHANNEL CLASS D AMPLIFIER

XC6610

・ 1,000 watts of maximum power output
・ 250 watts × 3 channel @ 4-Ohms Bridged
・ 125 watts × 6 channel @ 2-Ohms
・ 85 watts × 6 channel @ 4-Ohms
・ Conformally coated PC board
・ Stainless hardware
・ MOS-FET Power Supply
・ High/Low Pass Electronic Crossover, 50Hz-500Hz
・ Variable 12dB/Oct. Bass boost for CH5/CH6
・ Variable gain control
・ 2 × 40 Amp ATC fuses
・ Switchable High level auto sense
・ Soft turn-on and turn-off circuitry
・ Ground loop isolation circuit
・ Corrosion resistant RCA, Power, and Speaker connections

Class D Amplifier Design

Using MOS-FET power devices, the Class D amplifier circuitry is able to deliver incredible performance in compact dimensions. In a digital amplifier a Pulse-Width Modulator (PWM) expresses a low-frequency audio signal as a wide pulse, and a high-frequency audio signal as a narrow pulse. This then undergoes digital-to-analogue conversion for output, which is the basis of any digitally recorded media hence excellent affinity to digital sources. High power conversion efficiency means less power wasted and less heat generated, therefore an absence of bulky heat sinks.

Circuit Design Achieves High Quality Sound

Circuit Design Achieves High Quality Sound Clarion amplifiers feature uncompromising resistance to magnetic noise, thereby minimizing distortion, as well as high quality block terminals to offer low electrical and contact resistance. Easy subwoofer system configuration is possible with the embedded high pass and low pass filters. The result is high quality sound you can enjoy in a variety of systems.
* except for XC1410
XC6610_02

MOS-FET Power Amp

There' s only one way for Clarion's main units to deliver unyielding power output and linearity: MOS-FET amplification, or Metal Oxide Semiconductor Field Effect Transistor amplification. Smaller and more efficient than conventional power supplies, a MOS-FET amplification circuit delivers power with less distortion and zero On/Off switching noise. This means you can crank up the volume or set it to easy listening. Either way, your sound will be crystal clear.

2-Ohm Stability

Utilizing this design for peak performance and unwavering reliability, Clarion's amplifiers can drive lower impedance loads for increased power.
XC6610_02
CEA Power Output:
 125W × 6 RMS (2Ω@14.4V≤1% THD+N)
 85W × 6 RMS (4Ω@14.4V≤1% THD+N)
Signal to Noise Ratio:
 80dB (Ref; 1W into 4Ω)
  1. Home
  2. Personal Products
  3. Marine Audio System
  4. XC6610
  5. Highlight

Top page